This exhaust line fits :
> All the 964
It's a complete line including spaghetti-shaped headers (without heating) and a central rear muffler. The Lambda probe is fitted to the left hand header. The twin tail-pipe versions will give a greater sound than the single ones, which makes this version the quietest. This is the one we would recommend for track use.
Our range also includes the following lines :
> A single tail-pipe, super sound version - (Reference : SCA 964 R1 +)
> A twin tail-pipe, sport version - (Reference : SCA 964 R2)
> A twin tail-pipe, super sound version - (Reference : SCA 964 R2 +)
This line replaces the entire original exhaust line (+20hp).
On average it takes about 4 hours to fit, including the time it takes to remove the original exhaust. It will be faster if the exhaust you're removing is in good condition, just as it may take longer if the reverse is true.
You will need a car hoist for the job.
It is important to respect the maker's tightening torque. If the exhaust fitting is insufficiently or overly tightened you could end up with an air leak. Remember that the bolts must always be tightened progressively across the whole set of bolts....
To ensure that our exhausts are fitted under the best conditions a mounting kit containing: gaskets, stainless steel bolts, stainless steel lock nuts, high temperature copper grease as well as the 2 SCART straps is included with this exhaust. We recommend that you use the copper grease on the thread of the bolts and on the gaskets when fitting.