This intermediate pipe fits the :
> 911 2.7L
> 911 3.0L
> 911 3.2L
It connects the right-hand side header to the pre-muffler. The flexibility of the 100% stainless steel pipe means that it will absorb the vibrations and dilation caused by the heat. It is designed for a stress-free fitting avoiding the removal of the left-hand side header.
Our exhausts all fit onto the original interfaces. By this we mean their entry, their outlet and their size conform to the original part. They can therefore be fitted in replacement of the original part without requiring any modification. The indentation on its underside is there to enable you to pass the return spring of the clutch.
On average the fitting time is 1 hour, including the time taken to dismount the original exhaust. Fitting time will be faster if the exhaust you're dismounting is in good condition, just as it may take longer if the reverse is true, as is often the case when the bolts are the original ones. It's quite common to have to cut the pipe in half in order to remove it.
You will need a car hoist for the job.
It is important to respect the maker's tightening torque. If the exhaust fitting is insufficiently or overly tightened you could end up with an air leak. Tightening of the bolts must always be done progressively across the whole set of bolts... you will need to fit the 3 bolts on each side, tightening as you go, after that you can tighten the clamp.
To ensure that our exhausts are fitted under the best conditions, a mounting kit containing: gaskets, stainless steel bolts, stainless steel lock nuts and high temperature copper grease, is included with your exhaust.